Uniden WDECT 3315 - Manual (Page 41)

[ 37 ]
Calling a party from the Caller ID list
From Standby mode
1) When the phone is in standby mode, view the Caller ID
message (see “Viewing the Caller ID List” on page 35).
2) Press or speaker. The displayed phone
number dials automatically.
From Talk mode
1) Press
or speaker.
2) View the Caller ID message you want to dial (see “Viewing the Caller ID List” on page 35).
3) Press
. The displayed phone number will be dialed.
Adding Zero to Caller ID message (New Zealand only)
While you review Caller ID information while the Insert Zero option is set to On, “0” is
inserted. Refer to page 15 “Setting Insert Zero (New Zealand only)” to set the Insert Zero
option to On or Off. New Zealand Telecom customers should leave Insert Zero to On. Other
New Zealand companies may require Insert Zero set to Off.
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone number and
name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, view the Caller ID message to be stored.
Then press
. Store/Edit Name appears.
2) To complete the setting, follow the steps 4-8 in “Storing Phone Numbers, Names, Distinctive
Rings, and Speed dial” on page 26-27.
uSing ThE CallEr iD MESSagE liST
• You cannot make a
call from the Caller ID
list if your phone is
connected to a private
branch exchange (PBX).
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
• If the Caller ID message
was received as a
private/unknown
number, or the message
does not have the
number, you cannot
store the message in
the Phonebook. If it
was received as private/
unknown name, the
message will be stored
as .
• Even if the 100 memory
locations are full, the
message will be stored
in the Phonebook.
However, the message
will be erased from the
Caller ID list.
21/12 11:20AM
Jane Smith
0295979035