Universal Remote Control (URS) DMS-AV TSP2000 - Manual (Page 41)

Page 42
DMS-AV H
OME
T
HEATER
A
MPLIFIER
Analog Audio Assign
(Available for HDMI inputs only) - Analog audio assign options may also be
used to reassign HDMI audio to any of the line level analog audio inputs
(IN 1 through IN 6).
Video Scaling
This allows setting of a desired output resolution per input selected by the
DMS-AV. All inputs, except phono, support a discrete video output
resolution mode. Also available is an “HDMI Bypass” mode, which is
essentially a mode that transfers the native resolution of the selected source
to the display monitor or projector, via the DMS-AV’s HDMI output.
A/V Sync
This setting allows correction for the native Lip-Sync A/V delay of the
connected video monitor, and the selected source. One video frame
is approximately 17 mS delay. A/V Sync allows for up to 200 mS of
A/V Sync correction. Modern HD monitors may have up to 5 frames
of perceivable delay.
DC Trigger 1
This setting allows DC Trigger 1 to be set to trigger a 12V DC signal
from DC Trigger 1 when a specific input is selected.
DC Trigger 2
This setting allows DC Trigger 2 to be set to trigger a 12V DC signal
from DC Trigger 2 when a specific input is selected.
Linking Audio Zones with the DMS-AV
The DMS-AV has the ability to create multicast audio streams for two
analog audio inputs. These streams can then be sent to URC DMS multi
zone amplifiers for the purpose of creating secondary audio zones with
sources that are connected to the DMS-AV. Please contact your URC
representative for more information regarding sharing analog sources with
other URC DMS multi zone amplifiers.