Universal Remote Control (URS) DMS-AV TSP2000 - Manual (Page 30)

Page 31
On Screen Display (OSD) Format
The DMS-AV on-screen Display allows for the complete system setup of the
DMS-AV, when using in an application that does not include a URC DMS Multi
Zone Audio System.
Momentary OSD
On-screen display information, such as volume level and input name can be
disabled, if desired. Within the System Setup section of the on-screen display, or
within the URC Accelerator PC Application, set this feature to “Off”, if desired.
Software Setup - URC Accelerator
URC Accelerator is the advanced PC application used to configure the
DMS-AV, the appropriate user interface remote control, and integration with
URC DMS Multi Zone amplifiers. Contact your URC representative to acquire
the URC Accelerator PC Application.
DMS-AV System Settings – Audio
Speaker Size/Speaker Crossover
Speaker size refers to the frequency range a speaker can handle. Audio
material, particularly Dolby Digital and DTS movies, often contain large
amounts of bass. If this bass information is sent to small speakers that are
incapable of reproducing bass, then this information will be lost or distorted.
Too much bass may damage small speakers. By configuring the DMS-AV for the
correct type of speaker crossover, all bass information will be appropriately
routed to the speakers that are best able to reproduce it correctly.
Typically bookshelf or satellite speakers are considered Small. Smaller floor
standing speakers with a single 8” or less woofer should also be considered
Small. Floor standing speakers with 10” or larger woofers, or multiple smaller
woofers may be considered Large. These are general guidelines only if you are
unsure, please consult your speaker manufacturer or dealer.
If using large speakers, the system may not require a subwoofer, however better
results may still be obtained with the use of a subwoofer. Even with speakers
that are capable of reproducing deep bass, better overall bass response may be
obtained by setting a crossover frequency for these speakers. This allows bass to
be reproduced from a single point (the subwoofer), and avoids the possibility of
phase cancellation which may occur when bass is reproduced from multiple
speakers simultaneously.
DMS-AV H
OME
T
HEATER
A
MPLIFIER