Uniden 2300 - Manual (Page 41)

[ 35 ]
Calling a party from the Caller ID list
From Standby mode
1) When the phone is in standby mode, view the Caller ID
message (see “Viewing the Caller ID List” on page 33).
2) Press or speaker. The displayed phone
number dials automatically.
From Talk mode
1) Press or speaker.
2) View the Caller ID message you want to dial (see “Viewing the Caller ID List” on page 33).
3) Press . The displayed phone number will be dialed.
Adding Zero to Caller ID message (New Zealand only)
While you review Caller ID information while the Insert Zero option is set to On, “0” is
inserted. Refer to page 14 “Insert Zero (New Zealand only)” to set the Insert Zero option
to On or Off. New Zealand Telecom customers should leave Insert Zero to On. Other New
Zealand companies may require Insert Zero set to Off.
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone number
and name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, view the Caller ID message to be stored.
Then press . Store/Edit Name appears.
2) To complete the setting, follow the steps 4-8 in “Storing Phone Numbers, Names,
Distinctive Rings, and Speed dial” on page 24.
USING THE CALLER ID MESSAGE LIST
• You cannot make a call
from the Caller ID list
if your phone is
connected to a private
branch exchange (PBX).
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
• If the Caller ID
message was received
as a private/unknown
number, or the
message does not have
the number, you
cannot store the
message in the
Phonebook. If it was
received as
private/unknown name,
the message will be
stored as .
• Even if the 100
memory locations are
full, the message will
be stored in the
Phonebook. However,
the message will be
erased from the Caller
ID list.
21/12 11:20AM
Jane Smith
0295979035
UP349BH (WDECT2300) ENG OM 5/12/04 10:54 AM Page 35