Uniden 2300 - Manual (Page 20)

Global Setup
Setting Name Tag (POP ID)
1) Enter the Global Setup menu, and then the Name Tag submenu (see “Entering the
Menu” on page 11).
2) Press /vol/ or /vol/ to change the selection, On or Off.
3) Press . You will hear a confirmation tone.
Setting Insert Zero (New Zealand only)
1) Enter the Global Setup menu, and then the Insert 0 submenu (see “Entering the
Menu” on page 11).
2) Press /vol/ or /vol/ to change the selection, On or Off.
3) Press . You will hear a confirmation tone.
Setting Day and Time
1) Enter the Global Setup menu, and then the Day & Time
submenu (see “Entering the Menu” on page 11).
2) Press /vol/ or /vol/ to select the day of
the week, and then press .
3) Press /vol/ or /vol/ to set hour and then
press .
4) Press /vol/ or /vol/ to set minute and then press .
5) Press /vol/ or /vol/ to choose AM or PM, and then press .
You will hear a confirmation tone.
Setting the Dial Mode (Australia only)
1) Enter the Global Setup menu, and then the Dial Mode
submenu (see “Entering the Menu” on page 11).
2) Press /vol/ or /vol/ to change the
select, Tone or Pulse (the initial setting is Tone).
3) Press . You will hear a confirmation tone.
[ 14 ]
Day & Time
SUN 12:00 AM
[ / / / /SELECT]
For setting the Day
and Time, the idle
time-out is extended
to 2 minutes.
Dial Mode
Tone
Pulse
UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 14