Uniden 2300 User Manual
Page 21
[ 15 ]
System Reset
De-register the Handset
1) Enter the System Reset menu, and then the Deregister
HS submenu (see “Entering the Menu” on page 11).
2) Press .
Deregister HS? appears.
3) Press
/vol/
or
/vol/
to select Yes.
4) Press
. You will hear a confirmation tone.
When de-registration is complete, Deregistration
Complete appears.
5) After de-registering the handset, move to “Replacing the
Base Setting” below.
Replacing the Base Setting
1) Enter the System Reset menu, and then the Replacing
Base submenu (see “Entering the Menu” on page 11).
Replace base? appears.
2) Press
/vol/
or
/vol/
to select Yes.
3) Press
. You will hear a confirmation tone.
The base information will be deleted.
When replacing the base is complete, Place handset on main base to
register appears, register the handset to the new base.
4) Place the handset in the base unit to begin registration.
5) While the handset is registering, “Handset Registering” will appear in the LCD.
When “Registration Complete” is displayed, the handset has been registered to
the base.
If “Registration Failed” appears, please try these steps again.
Deregister HS?
Yes
No
Which Handset?
Handset #1
Replace base?
Yes
No
Make sure to perform
the Replacing Base
after de-register
the handset.
UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 15