Uniden BT-1007 - Manual (Page 2)

5. Connect the AC adapter to the power jack on the base. Route the cord
through the notch.
6. Plug the other end of the adapter into a standard 120V AC outlet.
7. Place the handset in the base with the keypad facing forward. The
Talk/baTT
low light on the handset should light up; if it doesn’t, reseat the handset or
try plugging the AC adapter into a different outlet.
#
Charge the handset completely (about 15 hours) before using it.
Connecting the Telephone Cord
Connect the
TEL LINE
jack to a standard telephone wall jack.
Test the connection
1. Pick up the handset from the cradle and press Talk . You should hear a dial
tone, and the Talk/baTT low light should light up.
x If you don't hear a dial tone, try checking the connection between the base
and the phone jack.
2. Make a quick test call. (Press End to hang up.)
x If you keep hearing a dial tone, try changing to pulse dialing mode.
x If there is a lot of noise, see “Noise or Static on the Line” for tips on avoiding
interference.
Changing from Tone to Pulse Dialing
Your phone communicates with the telephone network in two ways: tone dialing
or pulse dialing. Most telephone companies use tone dialing. If your phone
company uses pulse dialing, you will need to change your phone’s dial mode.
1. In standby, press and hold
Flash until you hear a confirmation tone.
2. Press # to set your phone for pulse dialing. Press /TonE to set your phone
for tone dialing.
If you use pulse dialing and you need to send DTMF tones during a call (if you're
using an automated response system, for example), press /TonE to temporarily
switch to tone dialing. When the call ends, the phone automatically returns to
pulse dialing mode.
Getting to Know Your Phone
Base
Key What it does
Find
- In standby: page the
handset.
Handset
Key What it does
Talk - In standby: start a telephone call (get a dial tone).
Flash
- During a call: switch to a waiting call.
MEMory
- In standby: store or erase a memory dial entry.
- During a call: access memory dial.
End
- During a call: hang up.
- While the phone is ringing: mute the ringer for this call only.
UP / down
- In standby: adjust the ringer tone and volume.
- During a call: adjust the earpiece volume.
rEdial - When you have a dial tone: redial the last number dialed.
PaUsE
- While creating a memory dial entry: insert a two-second pause.
MUTE
- During a call: mute the microphone.
- While the phone is ringing: mute the ringer for this call only.
Status light What it means
Talk/baTT
low
- On: the phone is in use.
- Blinking slowly: the battery pack is low.
Earpiece
TALK/
BATTERY
LOW
light
MEMORY
Microphone
12-key
dial pad
MUTE
END
FLASH
UP/DOWN
TALK
REDIAL
PAUSE
Charging
contacts
Charging
contacts
FIND