Uniden BT-1007 - Manual

Battery
cover
Rechargeable
battery pack
(BT-1007)
What's in the box?
AC adapter (PS-0035) Telephone cord
DECT1340 base
and cordless
handset
x If any items are missing or damaged, contact our Customer Care Line
immediately. Never use damaged products!
x Need help? Get answers 24/7 at our website: www.uniden.com.
If You... Contact Uniden’s... Phone Number
have a question or problem Customer Care Line*
817-858-2929 or
800-297-1023
need a replacement part or
an accessory
Parts Department* 800-554-3988
need special assistance due
to a disability
Accessibility Help Line 800-874-9314
(voice or TTY)
* During regular business hours, Central Standard Time; see our website for detailed busi-
ness hours.
DECT1340 Series User's Guide
Important Safety Instructions!
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
x This unit is NOT waterproof. DO NOT expose this unit to rain or moisture.
x Do not use this product near water, for example, near a bath tub, wash bowl,
kitchen sink or laundry tub, in a wet basement or near a swimming pool.
x Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
x Do not use the telephone to report a gas leak in the vicinity of the leak.
x Use only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode. Check with local codes for
possible special disposal instructions.
x Do not place the handset in any charging cradle without the battery installed
and the battery cover securely in place.
SAVE THESE INSTRUCTIONS!
CAUTION! Risk of explosion if battery is replaced by an incorrect type!
Dispose of used batteries according to the instructions. Do not open
or mutilate the battery. Disconnect the battery before shipping this
product.
For more details, see the Important Information section.
GETTING STARTED
Charging the Battery
1. Unpack the handset, battery pack, and
battery cover. If you need to remove the
battery cover, press in on the notch and
slide the cover down and off.
2. Line up the battery connector with the jack
inside the handset. (The battery connector
will only fit one way.)
3. Push the connector in until it clicks into place; tug gently on the wires to
make sure the battery pack is securely connected.
4. Replace the battery cover and slide it into place.