beautypg.com

7u r c - 1 0 0 – Universal Remote Control (URS) URC-100 User Manual

Page 9

background image

7

U R C - 1 0 0

Note:

If your component fails to turn off after you have

entered all the code numbers listed for your brand, you can
scan through the other brands in the table by alternately pressing
the Channel Up(or Down) and Power Off buttons (there is a
chance that your component was actually manufactured by
another brand). However, most of the code tables are so
large that it is usually faster to use the Learning Method on Page 8.

When the component turns off, save the code
number you entered by pressing the LIGHT button.

The Unifier responds by flashing SAVED on the
display twice, then returns to normal operating
mode.

When the display shows a device name, you are
back in normal operating mode. Now it’s time to
test all the buttons. If some buttons don’t work, try
repeating steps 1-6 with the remaining code
numbers, to see if you can improve the match to
your component.

For Example: My Sony TV powered off with TV code
number 147. However the number buttons didn’t work
when I tested them. So, I repeated steps one to six, using
other code numbers and eventually discovered that when
code number 185 is set, all the buttons work perfectly.

Repeat steps one through seven for each of your
devices. In most systems, you can finish basic
setup in just a few minutes and put all your old
remote controls away.

7

8

6

Channel Up

and Down

scan code

numbers.

LIGHT
Button