Uniden ALP9094 - Manual (Page 6)

Turning Your Pager On
Press and hold N for approximately two seconds.
The display will temporarily go blank and then show the
standby display (see page 6).
Turning YourPagerOff
1. At the standby display, press N to go the Function
menu (page 9).
2. Press
>
to select POWER OFF ( ).
3. Press N again and your pager is in the standby mode.
Low Battery Warning
When battery power is low, this symbol ( ) appears in
the bottom center of the display, and – once every 30
minutes – a low beep sounds that lasts four seconds.
When this happens:
●
Replace the battery as soon as possible to prevent data loss.
●
You will have to press N twice (instead of normally
pressing once) at the Standby display to go to the
Function menu (page 9).
4
NOTE
The built-in memory saver will store messages and
settings for approximately two minutes while you
change the battery - or after the battery loses power.