U-Line ICE-MAKER - Manual (Page 53)

51
Problem Possible Cause Remedy
No ice Bin arm locked in Lower bin arm.
upright position
No water to unit.
Turn on water or contact
plumber.
Not enough ice Control set too cold Adjust control to a
warmer setting
(COUNTERCLOCKWISE).
Ice cube size too Set cube size smaller.
large See ADJUSTING ICE
CUBE SIZE.
Dirty condenser coils. Clean condenser.
See CLEANING AND
MAINTENANCE.
Water leaks into Water level set too Set cube size smaller.
ice bucket high See ADJUSTING ICE
CUBE SIZE.
Fresh food section Ice bucket not fully Push ice bucket
on Combo units inserted into place.
too cold
Flap door not closed Be sure Flap door is
correctly closed correctly.
Unit too cold Temperature control Set control to warmer setting
set too cold (COUNTERCLOCKWISE).
IF SERVICE IS REQUIRED
If the need for service arises, contact the dealer from whom the unit
was purchased. State the Model Number and Serial Number and
explain the problem. The Model and Serial Number plate is located
inside unit at upper right hand corner, except for models 95, 98 and
SP18, which have the plate located behind the ice bucket. If you do not
know the name of the selling dealer or local service company, you can
check on-line at www.U-LineService.com.
REPLACEMENT PARTS
Use only genuine U-Line replacement parts. Genuine U-Line parts are
designed to work correctly with U-Line products and offer superior ser-
vice life. The use of non-U-Line parts can damage the unit and may void
the warranty.
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 51