Trango Broadband M2400S - Manual (Page 26)

Basic Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A Page 22
AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter Description Related CLI Command
AP ID This parameter provides a
unique number for each AP. If
Target AP is specified on SU,
the SU can only authenticate
with the specified AP. The
default AP ID is the last two
bytes of the MAC address. set apid (00-FF in HEX)
Example:
#>set apid 33
Opmode Current Opmode of the radio. opmode on y
This sets the radio to Opmode “ON.” If the radio is
accessed via the Ethernet port within the first 30
seconds after reboot/power cycle, the Opmode will
default to “OFF.”
Default Opmode Determines the Opmode (“ON”
or “OFF”) of the radio after
reboot/power cycle. When this
parameter is set to “ON,” the
radio will progress into
Opmode “ON” automatically
after a reboot/power cycle. set defaultopmode
Example:
#>set defaultopmode on
Opmode Start Determines the amount of time
the radio will remain in
Opmode “OFF” after
reboot/power cycle before
progressing to the default
Opmode. set defaultopmode on []
Example:
#>set defaultopmode on 60
IP
Subnet
Gateway IP, Subnet, and Gateway
address of the radio. ipconfig [ gateway>]
Example:
#>ipconfig 10.1.1.2 255.0.0.0 10.1.1.1
TFTPD Status TFTPD status (on or off).
TFTPD should be turned on to
import a file into the radio
(such as new firmware).
Default is off. TFTPD will
revert to Off after rebooting. tftpd []
Example:
#>tftpd on