Tannoy V12HP - Manual (Page 16)

12.5 SECUR – ET VTH Pole Mount
12.6 SECUR – ET VCS Ceiling Saddle
12.7 SECUR – ET VPC Pole Clamp
The Tannoy V12HP loudspeaker is fitted as
standard with a blanking plate on the base
of the cabinet. However, should you ever
wish to mount the V12HP onto a standard
35mm pole mount this blanking plate can
be quickly and easily removed and
replaced by a VTH pole mount. The same
screws which secure the blanking plate
should be used to secure the VTH in
position.
VCS
The VCS ceiling saddle available in both
black and white finishes, and is to be used
in conjunction with the VMY and a length of
M10 threaded rod (not supplied by Tannoy
Limited). The VCS ceiling saddle allows the
Tannoy V12HP loudspeaker to be
suspended at a user defined distance from
the ceiling as shown in Figure 1.
Included with the VCS is an M10 nut. This
should be used to secure and lock the
threaded rod in place at the top of the
ceiling saddle.
Fig. 1
The VPC pole clamp can be used along with the
VMY yoke bracket to suspend a Tannoy V12HP
loudspeaker from an overhead bar, truss or
suitable structure. Only the parts supplied
should be used to secure the VPC to the VMY
yoke bracket.
The following items are included with each
VPC:-
Description Quantity
VPC Pole Clamp 1
M10 Washer 1
M10 x 50mm Screw 1
M10 Nyloc Nut (Black) 1