Tekkeon MP3450-10 - Manual (Page 5)

3 USER GUIDE
Getting to Know myPower ALL Plus
Charging myPower ALL Plus
myPower ALL Plus will charge in two hours when completely empty. The green Charge indicator will
turn on after the battery is 80% charged. Therefore, you should view the actual battery capacity before
disconnecting the power adapter to stop charging. (Before using myPower ALL Plus for the first time,
you must charge the device for two hours.)
1. Plug the power adapter into the DC IN jack on the end of myPower ALL Plus.
2. Plug the power adapter into a wall outlet. The red Charge indicator will turn on to indicate the battery is
charging and is less than 80% charged.
3. When the green Charge indicator turns on, and with the Power switch set to OFF, press the voltage
selector to view the battery capacity. If the capacity does not indicate full (all green LEDs on), continue
to charge the battery until the battery capacity indicates full.
NOTE: myPower ALL Plus will automatically shut down the power input when fully charged, so you can
charge it overnight.
Voltage Indicators/Capacity Indicators
Power
DC OUT
For connection
to device
DC IN For connection
to power adapter
Voltage Selector/
Capacity Display
USB Port for connection
to 5V device
Battery port for connection
to MP3450-10
Charging Indicator
MP3450 MP3450-10