TDK Module blu2i - Manual (Page 3)

Before You Begin
Congratulations on your purchase of the TDK Systems blu
2i Module.
The Module is designed to be built into a device and to provide a simple,
low cost Bluetooth interface. The module is designed to integrate with a
wide range of applications and platforms with a simple electrical and
software interface using AT commands.
This guide aims to provide all the electrical and mechanical information
needed to design applications using the blu
2i
Module. A separate
document, blu 2i Module - AT Command Set, outlines the protocol for the
software interface.
Safety Guidelines
The following safety precautions must be observed during all phases of
the operation, usage, service or repair of any application incorporating
this Bluetooth Module. Manufacturers of the RF equipment are advised
to convey the following safety information to users and operating
personnel and to incorporate these guidelines into all manuals supplied
with the product. Failure to comply with these precautions violates safety
standards of design, manufacture and intended use of the product. TDK
Systems assumes no liability for customer failure to comply with these
precautions.
RF Approvals
The blu
2i Module is listed as a Bluetooth Product in terms of the
Bluetooth SIG Program Reference Document (PRD). This means that it
can be integrated into end products without further testing or approval
listing. The manufacturer must state the TDK part number and product
reference in his literature in order to meet the requirements of the
Bluetooth and regulatory approvals.
A list of the countries where the module is approved will be provided by
TDK Systems as required. As a minimum the product is listed in Europe,
Scandinavia and USA. TDK Systems assumes no liability for customer
failure to comply with national RF approvals.
3 of 36