True Manufacturing Company GDIM-26 - Manual (Page 8)

6 6
LOCATING
............ www.truemfg.com ............
True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
Rail End
Lower Rail
Assembly
Snug Fit
Here
Leveling Shim
Castor Leg
Bearing
Race
Lower Rail Assembly
Snug Fit
Here
Rail End
Thread castor into the underside
of cabinet frame rail. Thread leg into cabinet bottom
frame rail.
The end of the leg is adjustable to
easy leveling.
Use the tool provided to tighten
the castor into place. For leveling, insert the shim between
the castor and frame rail.
1 2 3 4
5
INSTALLATION OF LEGS AND CASTORS
Important Safeguard for installation of leg/castor (Images 1-5 demonstrate procedure)
Securing Castors and Legs
To obtain maximum strength and stability of the unit,
it is important that you make sure each castor is secure.
Legs are hand-tightened securely against the lower rail
assembly. The bearing race on the castor of the top edge
of the leg must make firm contact with the rail.
Unit leveling
Four leveling shims have been provided for leveling
castored units positioned on uneven floors. Shims must
be positioned between rail end and bearing race.
A. Turn the bearing race counter-clockwise until the
cabinet is level. Level front to back and side to side.
(diagonally).
B. Install the desired number of shims, making sure the
slot of the shim is in contact with the threaded stem
of the castor.
C. If more than one shim is used, turn the slot at a 90°
angle so they are not in line.
D. Turn the bearing race clockwise to tighten and secure
the castor by tightening the anchoring bolt with a
3/4 inch open-end wrench or the tool provided.
CAUTION
To avoid damage to lower rail assembly,
slowly raise unit to upright position.
NOTE
Open holes located on the cross members of the frame rail
should be plugged before unit is in use.
A. Remove louver from the front of cabinet and backguard
(if applicable) from rear of cabinet.
B. Skid bolts are located in each of 4 corners inside cabinet
bottom. (See photo A).
C. Remove skid bolts. (See photo B).
D. Cut straps if applicable. (See photo C).
E. Carefully lift cabinet off of skid.
F. Applicance tested according to the climate classes 5
and 7 for temperature and relative humidity.
Removing skid from bottom
of cabinet.
A B
C