Troy-Bilt 2410 - Manual (Page 9)

Place chute onto chute base and ensure chute control 3.
rod is positioned under the handle panel. Install hex bolt
previously removed, but do not secure with wing nut at
this time. See Fig. 3-8.
Squeeze the trigger on the joystick and rotate the chute by 4.
hand to face forward. The holes in the chute control input
will be facing up. See Fig. 3-9.
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
Rotate the joystick to the one o’clock position so that the 5.
silver indicator arrow on the pinion gear below the control
panel faces upward. See Fig. 3-10.
NOTE: The joystick will be angled slightly to the right at the
one o’clock position. See “Top View” in Fig. 3-9.
Insert the chute control rod into the pinion gear below the 6.
joystick. Make sure to line up the hole in the rod with the
arrow on the pinion gear. See Fig. 3-11.
NOTE: The chute control rod will fit snuggly into the pinion
gear. Support the rear of the dash panel with one hand
while inserting the rod with your other hand to ensure the
rod is inserted all the way into the pinion gear.
NOTE: The hole is a reference for aligning the rod with the
indicator arrow on the pinion gear, and will be visible after
the rod has been inserted.
Top View Chute Control
Input
Figure 3-8
Figure 3-10
Figure 3-9
Figure 3-11
9 s
ectiOn
3 — a
sseMbly
& s
et
-u
p