Troy-Bilt 2410 - Manual (Page 14)

Auger Control
The auger control is located on the left handle. Squeeze the
control grip against the handle to engage the augers and start
snow throwing action. Release to stop.
Drive Control / Auger Clutch Lock
The drive control is located on the right handle. Squeeze the
control grip against the handle to engage the wheel drive.
Release to stop.
The drive control also locks the auger control so that you can
operate the chute directional control without interrupting
the snow throwing process. If the auger control is engaged
simultaneously with the drive control, the operator can release
the auger control (on the left handle) and the augers will remain
engaged. Release both controls to stop the augers and wheel
drive.
NOTE: Always release the drive control before changing speeds.
Failure to do so will result in increased wear on your machine’s
drive system.
Heated Grips (if so equipped)
CAUTION: It is recommended that you wear gloves
when using the heated grip. If the heated grip
becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position. To turn off the heated
grips, move the switch found on the rear of the dash panel to the
OFF position.
Standard Chute Directional Control (if so equipped)
T
The chute directional control is located on left side of the snow
thrower. To change the direction in which snow is thrown, rotate
chute directional control.
2-Way Chute Directional Control (if so equipped)
The 2-way chute directional control is located on the left side of
the dash panel.
To change the direction in which snow is thrown, squeeze •
the button on the joy-stick and pivot the joy-stick to the
right or to the left.
14 s
ectiOn
4 — c
OntrOls and
f
eatures