Toshiba CTX IPT/DKT - Manual (Page 158)

ADM/DSS Console
DSS Console
140
Strata CIX and CTX IPT/DKT Telephone 08/07
Calling a Station
To call a station’s extension from either a DSS console or a DADM, press the DSS
associated with the station.
A station call with a DSS button can be made on-hook or off-hook, and with Voice
First or Tone signaling. After pressing the button, treat the call like any other
station call made from a digital telephone.
DSS LEDs indicate whether the associated station is idle or busy. The LED is
steady red if the station is busy or ringing, and is not lit if idle. If all the station’s
PDN buttons are being used by other stations, the DSS LED of the station is lit
steady red, but the station may be idle. If the station is in the Do Not Disturb mode,
its DSS LED lights blinking red.
Transferring to an Idle Station
You can transfer internal or outside calls to an idle station from either a DSS console
or a DADM.
To transfer a call to an idle station
1. Press the DSS button corresponding to the station to be called.
The call is placed automatically on hold. The Line or extension LED flashes green
at double the on-hold rate, and the DSS LED flashes green. You hear a single ring
tone. (If using the Tone signaling mode, you hear successive ring tones.)
2. Announce the call.
With Tone signaling, you would have to wait for the called station to answer before
announcing the call.
3. Hang up.
The call rings the called station when you hang up. While the called station is
ringing, the DSS LED is steady red, and the Line LED flashes green at the on-hold
rate or if on a extension button, it goes idle.
When the called station answers the call, the DSS LED stays steady red, and the
Line LED becomes steady red.
4. If the station does not answer before a period set in system programming, the call
recalls your station.