The Singing Machine STVD-1001 - Manual (Page 21)

1) Open the battery compartment.
2) Place a 9V battery in the compartment as indicated by the polarity symbols (+ and -) marked inside the
compartment of the wireless microphone.
3) Close the battery compartment.
4) The switch on the wireless microphone has three settings:
1. ON - The switch is in the top position. The microphone will function. The red indicator light is on.
2. STANDBY - The switch is in the middle position. The microphone will not function. The red indicator light is
on.
The purpose of this setting is to maintain a connection between the microphone and the Singing
Machine when moving around the area in which it is being used. (This function could also be considered a
mute function)
3. OFF - The switch is in the bottom position. The microphone will not function. The red indicator light is off.
To ensure long battery life, please make sure that the wireless microphones is set to the OFF position when
not in use. When not in use for a long period of time, we recommend that you remove the DC 9-V battery
This wireless microphone system complies with Part 90 of FCC Rules. There is one frequency available for the
system. You must get a licence for the frequency you plan to use before you use the system.
Please look for this website
to apply the licence or phone to the nearest FCC offices and
contact them to get the necessary application. Licensibility depends on how you will use the system.
“IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or
the device is permitted. Any change to the antenna or the device could result in the system exceeding the RF
exposure requirements.”
Your wireless microphone contains a low power transmitter. When the EUT is powered on and it sends out radio
frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure
guidelines with safety levels for wireless devices.
To maintain compliance with the FCC's RF exposure guidelines hold the transmitter and antenna at least 1 inch (2.5
centimetres) from your face and speak in a normal voice, with the antenna pointed up and away from the face.
Insure that the antenna is at least 1 inch (2.5 centimetres) from your body when you using your wireless
microphone.
Use only the supplied antenna. Unauthorised antennas, modifications, or attachments could damage the
transmitter and may violate FCC regulations.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of the device.
NOTE:
NOTE:
Warning: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC NOTICE
For RF exposure
SAFETY INFORMATION
IMPORTANT
from the
battery compartment.
http://wireless.fcc.gov/uls/
SMM-107B WIRELESS MICROPHONE OPERATION
WIRELESS MICROPHONE INFORMATION
ENGLISH
E20