Toshiba IK-SX1L - Manual (Page 20)

20
11. SPECIFICATIONS
10. TROUBLESHOOTING CHART
Symptoms
No image
Possible causes
• Is power properly supplied?
• Is the lens iris adjusted properly?
• Is the CRT monitor adjusted properly?
• Is the shutter mode set correctly?
* Design and specifications are subject to change without notice.
Power supply
Power consumption
Image sensor
(Effective pixels)
Scanning system
Scan frequency
Sensitivity
Lens mount
Ambient temperature
Ambient humidity
Weight
External dimension
Gain
Video output
Electric shutter
Mode
Partial scanning
Sync signal output
External trigger input
Optional parts
DC12
±
10%
Approx. 1.7W
2/3inch Progressive Scanning CCD
(Horizontal: 1392 pixels, Vertical: 1040 pixels)
Noninterlace
Horizontal: 15.998 kHz, Vertical: 14.98 Hz
F16 600 lx (GAIN OFF)
C mount
32 to 104
°
F (0 to 40
°
C)
Less than 90%
Approx. 4.77 oz (135g)
1.73" (W) x 1.73" (H) x 2.05" (D)
(44 (W) x 44 (H) x 52 (D) mm) (except for protruded portion)
ON (-3 to 12 dB), OFF (0 dB)
IK-SX1L: EIA RS-644 LVDS video 8-bit digital output
IK-SX1:
Camera link video 8-bit digital output
1/15s, 1/100s, 1/500s, 1/1000s, 1/2000s, 1/4000s,
1/10000s, 1/50000s
Internal synchronization, internal synchronization draft,
internal synchronization partial scanning
1-Pulse trigger, 1-pulse trigger partial scanning
Pulse width trigger, Pulse width trigger partial scanning
Scanning area 1/15 (70 lines, 6 fps)
Scanning area 1/2.6 (400 lines, 30 fps)
Scanning area 1/2 (560 lines, 24 fps)
Scanning area 2/3 (700 lines, 20 fps)
HD, VD/LEN, FEN LVDS format (IK-SX1L)
Camera Link format (IK-SX1)
PCK (28.63636 MHz) LVDS format (IK-SX1L)
Camera Link format (IK-SX1)
TRIGGER; Low level: Less than 0.4V, High level: 3.4 to 5V
Negative
More than 20
µ
s pulse width
EXC-SX03M (cable for IK-SX1L), EXC-SX03A (cable for IK-
SX1L), EXC-CL05 (cable for IK-SX1), etc.