Targus netlink e340 - Manual (Page 21)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Key 1-4 : Scroll to the key option that corresponds to the Default Key that
was entered above. Enter the encryption key as a sequence of hexadecimal
characters. (Use the
2 and 3 keys to access hexadecimal digits A-F, use the
Right Arrow key to advance to the next digit, and the Left Arrow key to
backspace.) For 40-bit keys you will need to enter 10 digits, for 128-bit
keys you will need to enter 26 digits. The display will scroll as needed.
Rotation Secret : This is used for proprietary WEP key rotation. Refer to your
custom document if this feature is supported in your system.
Cisco FSR (Fast Secure Roaming) In order to provide the highest level of security
without compromising voice quality on Cisco Aironet wireless LAN access points,
SpectraLink and Cisco Systems have cooperated to implement the Fast Secure Roaming
mechanism. FSR is designed to minimize call interruptions for NetLink Wireless
Telephone users as they roam throughout a facility. Existing Aironet 350, 1100, and 1200
APs may require a firmware upgrade to support FSR. Cisco FSR requires advanced
configuration of the Cisco access points in your site. See your Cisco representative for
detailed documentation on configuring your access points and other required security
services on your wired network. To configure Cisco FSR in your NetLink Wireless
Telephone, you must enter a Radius Server username and password into each handset.
Username: Enter a username that matches an entry on your Radius server.
Usernames are alphanumeric strings, and can be entered using the alphanumeric
string entry technique.
Password: Enter the password that corresponds to this Username.
Clear PIN Number
The PIN number is saved in the Wireless Telephone’s local memory. If it is necessary to
change the PIN number assigned to this Wireless Telephone, clear the existing number
through this Admin menu option and power cycle the Wireless Telephone. The PBX will
request a PIN number when the handset is powered on, just as it does with the 5220 IP
Phone. Enter the PIN number and press the
Save softkey. The new PIN number is saved
in the Wireless Telephone’s local memory.
5220 Emulation
Disable 5220 is the default and should be used if configuring for the SX-200 ICP or the
3300 ICP is using software version 5.1 or greater. With this revision, the Mitel Networks
system became capable of recognizing NetLink Wireless Telephones. If the 3300 ICP
software version in use is below 5.1, select
Enable 5220 to allow Mitel Networks to
recognize the NetLink Wireless Telephone as a 5220 IP Phone.
OAI On/Off
SpectraLink’s Open Application Interface (OAI) enables third-party computer
applications to display alphanumeric messages on the Wireless Telephone display and
take input from the Wireless Telephone keypad. Refer to the Open Application Interface
(OAI) Specification (Version 1.2) documentation for information about administering the
OAI Gateway and the services it can provide.
PN: 72-1084-02-D.doc Page 21