Toshiba SD-1810 - Manual (Page 17)

17
OUT PUT
COMPONENT
Y
L
R
P B
P R
S-VIDEO
OPTICAL AUDIO
VEDIO
COAXIAL
DIGITAL
To P R
VIDEO
OUT
Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the
DVD video player away from the tuner and radio.
• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power
on, the speakers may be damaged.
Connecting to an audio system and TV equipped with component video inputs
Signal flow
To audio inputs of
the amplifier
(red) (white)
(red) (white)
To Y
VIDEO
OUT To P B
VIDEO
OUT
To Y video
input
To P B video input
To P R video input
TV or monitor with
ColorStream
®
component video inputs
Audio system
Component video (ColorStream ® ) outputs/inputs
Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy
the highest quality DVD picture playback.
Set the COMPONENT/S-VIDEO switch to the COMPONENT position.
Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, C
B , C R )
In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum performance.
To AUDIO OUT
2B50101A P12-21 8/21/02, 3:27 PM 17