Tascam CD 450 - Manual (Page 9)

TASCAM CD-450
9
Settings you make here are stored in EEPROM so they
become default settings.
1
Hold STOP and press POWER to enter a
preference setting mode.
2
Use the SKIP keys to select the desired items.
E)SEF = EOSET: End-of-Message triggering
time setting; 5 to 35 seconds, in 5-sec-
ond steps.
FALLY = TALLY: Tally signal output timing; at
EOM or STOP time.
F_P{H = F-PCH: Fixed pitch; +/–12%
FPLAY = TPLAY: Timer controlled play; On or
Off.
A_{
–60, –54 dB
They are factory preset to
OFF
EOM
OFF
OFF
–72 dB
respectively.
3
Set the necessary parameters with the SEARCH
keys.
4
To terminate the preference settings, let
"SEnd" (SEnd) show by operating the SKIP
keys, and then press any transport key (except
for the SKIP keys). The deck will go into the
mode pressed.
* To reset all your settings and restore the factory
presets, hold the CLEAR key and press the
POWER switch once after turning the unit off.
Preference Settings
Search Operations
Tracks
1
If either LED (TIME or INDEX) is lit to the left
of the SEARCH MODE key, press this key to
turn the LED off. When neither LED is lit, the
deck is in the track search mode.
2
Enter the desired track number on the numeric
keypad.
Playback starts from the beginning of the track
specified if you let the search operation start from
STOP.
*To specify track 5 for example, press 0 then 5.
* If you enter wrong numbers, press CLEAR
before entering the correct numbers.
Indexes
1
Press the SEARCH MODE key to let the INDEX
LED light up.
2
Enter a track number then an index number on
the numeric keypad.
The deck starts playing from the indexed point
designated if you let the search operation start
from STOP.
Time Points
1
Press the SEARCH MODE key to let the TIME
LED light up.
2
Enter a track number then a time point.
The deck starts playing from the time point desig-
nated if you let the search operation start from
STOP.
Operations