Toshiba D-R3 - Manual (Page 45)

44 - English
R
ecording
3 Press the OK button.
● The information concerning the programme is
displayed.
● When using the Video Plus+ function for the
first time with stored stations, the programme
number flashes. This one time, you must enter
the PR number manually by pressing the
†… buttons.
4 If the programme and times are correct,
press the OK button.
5 Turn the power off by pressing the
STANDBY/ON button to activate the
Timer Recoding setting.
6 Refer to page 41~43 if you wish to:
● Check whether the timer Recording has set
correctly or not.
● Cancel a preset recording
Before presetting your DVD Recoder:
• Switch on both the television and your DVD
Recoder.
• Check that the date and time are correct.
Up to twelve programmes can be preset.
1 Press the Video Plus+ button.
- A message is displayed to allow you to enter the
Video Plus+ code.
Using the MENU button.
●
Press the MENU button when the disc has
stopped.
● Press the …† buttons to select “Programme”, and
then press the OK or √ button twice.
2 Press the numeric buttons to enter the
code of the programme that you wish
to record in your television magazine.
● If you wish to correct the Video Plus+ code that
you are entering:
●
Press the œ button until the digit to be corrected
is cleared
●
Enter the correct digit
Using the Video Plus+
Feature
RETURN OK EXIT
Programme DVD-RAM(VR)
Enter Video Plus+ Code number. [0~9]
RETURN OK MOVE EXIT
Scheduled Record List DVD-RAM(VR)
01 PR 01 01/ 01 12:00 14:00 Once SP Off √√
02 -- -- --- -- --:-- --:-- -- -- -- √√
No. Source Date Start End Type Mode V/P Edit
Remaining Recording Time 02:12 SP
RETURN OK MOVE EXIT
Scheduled Record List DVD-RAM(VR)
01 -- -- --- -- --:-- --:-- -- -- -- √√
No. Source Date Start End Type Mode V/P Edit
Remaining Recording Time 02:12 SP
No. 01
Source PR 01 Date 01 JAN
Start 12 : 00 End 14 : 00
Type Once Mode SP
V/P Off
■ The numbers next to each TV programme
listing in the magazines or newspapers
are Video Plus+ code numbers, which
allow you to programme your video-
recorder instantly with the remote control.
Enter the Video Plus+ code for the
programme you wish to record.
■ Video Plus+ is a trademark of Gemstar
Development Corporation. The Video
Plus+ system is manufactured under
licence from Gemstar Development
Corporation.
NOTE
00566A-D-R3_36~46 8/31/04 10:29 AM Page 44