Topcom BUTLER 900 - Manual (Page 17)

Eng
lish
14
Technical data
12 Technical data
13 Default settings
Not possible to dial a number Wrong dial mode see ”7.11 Setting the dialling
mode” to set the correct
dialling mode
The icon flashes Handset out of range Bring the handset closer to the
base
The base has no power supply Check the mains connection
to the base
The handset is not registered on
the base Register the handset on the
base
Base or handset do not ring The ringing volume is off or low Adjust the ringing volume
Not possible to transfer a call
on PABX The Flash Time is too short Set the unit to Long Flash
Time
Telephone does not react to
pressing the keys Manipulation error Remove the batteries and put
them back in place
Range up to 300m in open space
up to 50m indoors
Handset Batteries: 2 x 1.2V, 600mAh AAA Type NiMh rechargeable
Base powersupply 220/230V / 50 Hz
Handset autonomy 100 hours in standby
Handset talk time 11 hours
Normal conditions of use +5 °C to +45 °C
Permitted relative air humid-
ity 25 to 85%
Dialling mode Pulse / DTMF (Tone)
Memories 10 indirect with max. 25 digits
Flash time 100 ms
Dialling mode: Tone
Ring volume Level 3
Ring melody Ringer 8
Base PIN 0000
Symptom Possible cause Solution