Topcom CLIP 160 - Manual (Page 7)

7
Clip 160
7 7 7
The Caller-ID list maintains the data of the last 90 incom-
ing calls. Press the Up button to show the previous (older)
calls on the display. After the oldest call “TOP OF LIST”
appears on the display. Press the Down button and the
display shows the next (more recent) call. After the most
recent call, the display shows “END OF LIST”.
8 To enter names in the Caller-ID List
It is possible to add a name to each received call in the
Caller-ID List. This makes it possible to use the list after-
wards as a phone book to look up numbers. By adding a
name to a number, this name will also be shown on the
display when you receive another call from the same
number. The device automatically returns to standby
mode, when, during programming, no buttons are being
pressed for 30 seconds.
Take the following steps to enter a name:
1
P ress the Up and Down buttons to go to the desired call.
2 Press and hold the Call Back button for 3 sec. to enter
the menu. The cursor appears on the third line of the
display.
3 Press the Up and Down buttons to select the correct
letter. To advance faster, keep the buttons pressed for
2 seconds.
4 Press the Delete button to erase letters if a mistake
has been made while entering the name.
5 Use the Call Back button to move the cursor into the
right direction.
6 Repeat steps 3 to 5 to enter the other letters of the
name.
7 After having entered the name, press and hold the
Call Back button for 2 seconds to confirm.