Topcom 2000 - Manual (Page 68)

69
Butler 2000
69 69 69 69
5.14 Change Master PIN Code (base station)
The master PIN code is an essential part of the sytem. Therefore it should be
changed as soon as possible. The factory setting is 1590. The new master PIN code
will only replace the current one, if the PIN code is entered correctly twice and if
the below mentioned procedure is not interrupted.
• Press the Function button until “BASE SETTING”
is displayed.
• Press the OK button.
• Press the Function button until “B-CHANGE PIN”
is shown on the display.
• Press the OK button.
• On the display “FP PIN :” is shown.
• Enter the current PIN code and press the
OK button.
• “WAIT” is displayed for a moment. When “NEW
PIN” is displayed, enter the new Master PIN code.
• Press the OK button.
• On the display “RETYPE PIN :” is shown.
• Enter the new Master PIN code for the 2nd time.
• Press the OK button to confirm.
ATTENTION : Do not forget your personal PIN code !
5.15 Base unit Reset
The user can reset the base unit to default factory values. This reset also desubscribes
all connected handsets. There are two possibilities:
1: RESET ALL
Subscribed handsets No handsets subscribed
2: INITIALIZE
All default parameters have been reset.
Base unit ring volume Level #9
Base unit ring melody Melody #4
Master PIN code 1590
Call Barring All barred numbers and the assigned
handsets are cleared.
RETYPE PIN:
BASE SETTING
B--CHANGE PIN
FP PIN:
NEW PIN: