Topcom 2000 - Manual (Page 61)

62
Butler 2000
62 62 62 62 62
Note : When you select “BASE NO : AUTO”, the base unit is searched automatically. If there are
more than two base units, the handset selects an arbitrary base station. This is only possible when
the handset is subscribed to several base units.
5.2 Select a base station
• Press the Function button until “SELECT BASE”
appears on the display.
• Press the OK button.
• The base number is shown on the display, for ex.
“BASE NO : 1”.
• Press the Function button.
• The base numbers appear on the display
“BASE NO : 1 ~ 4, AUTO”.
• When the desired base number is shown on
the display, for ex. “BASE NO : 2”, press the
OK button.
• Let’s assume that the handset was subscribed to base unit 2 and that the handset
number is now “MULTI 1”. If you want to sub-
scribe this handset to base unit 2 again, select de
base unit “BASE NO: 2” and press the OK button.
Display :“NEW BASE:2”
Note : If the handset was never subscribed to
base station 2, the following is displayed :
“NOT SUB2”.
• On the display “BASE : 2” is shown.
• Press the OK button to subscribe the new base
s t a t i o n .
• The unit returns to idle mode, “MULTI 2” appears
on the display.
5.3 Subscribing a handset to a base station
To be able to make and receive telephone calls, the handset must be subscribed to
the base unit.
NEW BASE: 2
NOT SUB2
BASE: 2
MULTI 2
SELECT BASE
BASE NO: 1
BASE NO: 2