Toshiba 36HF13 - Manual (Page 15)

Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
Index
15
(E) 36HF13
1 2 3
4 5 6
7 8 9
ENT 100 0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO MUTE
TV
CABLE
VCR
CH RTN
PIC SIZE
EXIT
LIGHT
STOP SOURCE
ADV/
PIP CH
ADV/
PIP CH
FAV FAV
PLAY PIP
FAVORITE
MENU/
STROBE
ENTER
Note:
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
POWER
Channel yz
Channel
Number
Enter
RECALL
Programming the remote control
The remote control is preprogrammed to operate most Toshiba VCRs
and cable TV converters. To program the remote control to operate a
non-Toshiba device or a Toshiba device that the remote control is not
preprogrammed to operate:
1. Refer to the “VCR code table” or “Cable TV converter code
table” on pages 16–17 to find the corresponding code for your
VCR or cable TV converter brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are reprogramming the remote control to operate your:
• VCR: Set the TV/CABLE/VCR switch on the remote control
to VCR.
• Cable converter: Set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. While holding down the RECALL button, press the Number
buttons (0–9) to enter the three-digit code for your VCR or cable
TV converter.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR or converter responds, you have entered the correct
code.
If the VCR or converter does not respond, you may have entered
the wrong code. Repeat steps 1–4 using another code.
Note: In addition to POWER, confirm that all necessary keys on the TV
remote control operate your device. If some keys are not operational, repeat
the device code setup using another code (if other codes are listed for your
device). If, after trying all listed codes, the necessary keys do not operate
your device, use the device’s original remote control.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR code ________________________________
Cable TV converter code ____________________