Teledyne MX300-I - Manual (Page 16)

Operating Instructions MX300-I
Teledyne Analytical Instruments
8
Warning: The MX300-I oxygen Monitor, R17MED oxygen sensor, and associated
hardware are non-sterile devices. Autoclaving or other chemical clean-
ing may damage the Monitor and the sensor.
2. Plug one end of the coiled cable into the receptacle on the back of the
R17MED sensor and secure it in place with the capture nut located at the
base of the connector. See Figure 2-1.
Figure 2-1: Installing the R17MED Sensor
3. Plug the other end of the cable into the receptacle located on the side of the
unit and secure it using the capture nut. See Figure 2-2.
Figure 2-2: Sensor Cable Connection to Monitor
Note: Cable shown is for illustration purposes only.