Inserting batteries operation – Toshiba MD20P1 User Manual
Page 12
12
Introduction
1
2
3
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30
°
angle on either side of the remote sensor, up to a distance of approx. 5
meters.
Replace the compartment
cover.
Install two “R03/AAA”
batteries (supplied), paying
attention to the polarity
diagram in the
battery
compartment.
Slide the battery compartment
cover in the direction of the
arrow.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (follow battery
manufacturer’s directions).
Inserting batteries
Operation
Approx. 5 meters
5K50101B [E] (P08-12)
20/4/04, 15:36
12