Unpacking and placement – Perreaux ECD2 User Manual

Page 7

Unpacking and Placement

The ECD2 is packaged for maximum protection. Please carefully read the
instructions below before proceeding to unpack the unit. Be extremely careful.

Unpacking

Procedure

àInspect both ends of the cardboard box and open at the end without the

central staple by slitting the reinforced tape at either side.

àFold back the flaps and tip the package on end and the inner box will

slide out.

àLay the inner box down flat and upright, open it conventionally by

separating the top tray from the bottom.

àThe product can now be removed from the bottom packaging. This will

be easier if you have someone to help you by holding the base of the
box.

àAlternately, the bottom tray and player could be tipped upside down

and the bottom packaging removed. If opened in this manner, please
ensure that you turn the contents over again.

Note: Be very careful to secure the unit if you are planning to flip the package

upside down.

àRemove the two white polystyrene protectors off either side of the

player , leaving the black material covering.

àPull back the material and remove the protective black tissue from the

front panel.

The player is now unpacked and ready for further installation.

Note: Please retain all packaging material for future transport.

Box

Contents

1 x ECD2 Compact disc player
1 x ECD2 Product manual
1 x Perreaux remote control
2 x AAA batteries
1 x Detachable AC power cord

Placing

Your ECD2

The ECD2 should generally be placed close to your amplifier, keeping the
interconnect cabling short.