beautypg.com

Timex W-248 User Manual

Page 25

background image

Selecting a Target Heart Rate Zone

You can choose one of the preset target heart rate zones or set the
manual target heart rate zone for a more customized target heart rate
zone. The preset heart rate zones described in the table below correspond
to your maximum heart rate (MHR) value.

To choose a target heart rate zone:

1. Determine the zone you want to use by reviewing the table on

page 7.

2. Press MODE until HRM Setup Mode appears.

3. Press START/SPLIT to cycle through the target heart rate zones

(labeled ZONE 1 to ZONE 5 or MANUAL).

4. For preset heart rate zones, press MODE to save your selected target

heart rate zone and exit HRM Setup Mode. For the manual heart rate

43

1. Remove the chest strap from your body, and let it sit for at least five

minutes to ensure it is completely shut down.

2. Find a location far away from any other Heart Rate Monitor chest

straps that may be transmitting.

3. On the watch, repeatedly press the MODE button until HRM Setup

appears in the top line of the display.

4. Press and hold the HEART RATE button. The message HOLD TO PAIR

should appear for about two seconds, followed by the instructions
WEAR STRAP, then PRESS MODE TO PAIR WATCH WITH STRAP.

5. Press the MODE button. A message saying WAIT FOR BEEP should

appear. The watch is now searching for a chest strap with which to
pair.

6. Now pick up your chest strap and hold it firmly with your thumbs

touching the sensor pads that normally contact your chest. Rub your
thumbs back and forth across the sensor pads a few times. This
contact should be enough to start the strap transmitting.

7. If the pairing operation completes successfully, PAIRING DONE will

appear on the display and a confirmation tone will sound. If for some
reason the pairing fails, repeat the above steps immediately beginning
with step 4.

42

Zone

Lower Limit

Upper Limit

1

50%

60%

2

60%

70%

3

70%

80%

4

80%

90%

5

90%

100%

To properly pair the watch with the Heart Rate Sensor, you must go directly to HRM
Setup Mode without stopping at any other mode first.

W248_EU_EN.qxp _TMX_M632 10/5/09 11:11 AM Page 42

This manual is related to the following products: