Toshiba TEC B-SX4T-QP - Manual (Page 21)

2. PRINTER SETUP ENGLISH VERSION EO1-33034
2.7 Loading the Media
E2-10
2.7 Loading the Media
(Cont.)
Build-in rewinder mode
The Rewinder Assembly of the Strip Module can be used in batch mode
to take up the printed media as a Built-in Rewinder.
(1) Remove the two Black Screws to detach the Front Plate.
(2) Attach the Rewinder Guide Plate enclosed with the optional Strip
Module to the Strip Plate with the SMW-4x8 sems screws.
(3) Insert the media under the Rewinder Guide Plate.
(4) Wind the media onto the Take-up Spool and fix it in position with
the Take-up Clip.
(5) Rotate the Take-up Spool counterclockwise a few times to remove
any slack in the media.
(6) Set the Selection Switch mounted on the Rewinder Assembly to
REWINDER position.
Cut mode
When the optional Cutter Module is fitted, the media is automatically cut.
A swing cutter and a rotary cutter are available as an option, but they are
used in the same way.
Insert the leading edge of the media into the Media Outlet of the Cutter
Module.
13. If the loaded media is direct thermal media (a chemically treated
surface), the media loading procedure is now completed. Close the
Ribbon Shaft Holder Plate, and turn the Head Lever to
Lock
position to close. Then, close the Top Cover.
If the media is thermal transfer media, it is also necessary to load a
ribbon. Refer to Section 2.8 Loading the Ribbon.
CAUTION!
1. Be sure to cut the backing
paper of the label.
Cutting labels will cause
the glue to stick to the
cutter which may affect
the cutter quality and
shorten the cutter life.
2. Use of tag paper when
the thickness exceeds the
specified value may affect
the cutter life. Media Outlet
Media
Cutter Module
NOTE:
Be sure to set the Selection
Switch to REWINDER position.
ADJUSTMENT:
If the media skews when using
the Built-in Rewinder, turn the
Adjustment Knob of the
Rewinder Guide Plate to correct
the media feed. Clockwise turn
moves the Rewinder Guide Plate
forward and counter-clockwise
moves it backward.
When the media skews to the
right:
Loosen the SM-4x8 screw, turn
the Adjustment Knob clockwise,
and then tighten the SM-4x8
screw when the Rewinder Guide
Plate is positioned correctly.
When the media skews to the left:
Loosen the SM-4x8 screw, turn
the Adjustment Knob counter-
clockwise, and tighten the SM-
4x8 screw when the Rewinder
Guide Plate is positioned
correctly.
Rewinder
Guide Plate
SM-4x8 Screw
SMW-4x8 Screw
Adjustment Knob
The cutter is sharp, so care
must be taken not to injure
yourself when handling the
cutter.
WARNING!
NOTE:
When using the Rotary Cutter, be
sure to install the Ribbon Saving
Module (B-9904-R-QM).
Failure to do this may cause a
paper jam or ribbon error.