Top Innovations SF-475 - Manual (Page 12)

12 Top Innovations, Inc.
T
ROUBLESHOOTING
G
UIDE
PROBLEM POSSIBLE CAUSE SOLUTION
Unit fails to steam. Lighted
On/Off Switch does not
illuminate. Unit is not plugged in. Plug into electrical
outlet.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse. Reset Circuit Breaker /
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a licensed
electrician.
Unit fails to steam. Lighted
On/Off Switch does
illuminate. Water Reservoir is empty. Refill Water Reservoir using
procedures on page 9 of this
manual.
Mineral build-up in unit. Follow Removing Mineral
Build-Up procedure on page
11 of this manual.
Steam output is intermittent. Mineral build-up in unit. It is normal for unit to
periodically stop steaming
for a few seconds. If steam
stays off for longer periods,
follow Removing Mineral
Build-Up procedure on page
11 of this manual.
Unit is emitting excess water. Water condensation in Steam
Hose. Point Steam Nozzle towards
sink, tub or ground and
shake. Continue until excess
water is released.
Water Reservoir has been
over-filled. Empty some water out of
Water Reservoir.
Unit has not reached
operating temperature. Wait until Steam Ready
Light deactivates to steam.
Excessive gurgling in Hose
and Steam Nozzle / water
drips from Steam Nozzle. Condensation in Steam Hose. Some gurgling is a natural
effect of steaming process.
For excessive gurgling or
dripping water, extend Hose
vertically to allow water to
drain back into Water
Reservoir.