Top Innovations SF-475 - Manual (Page 10)

10 Top Innovations, Inc.
U
SING THE
F
ABRIC
S
TEAMER
OPERATING THE F
ABRIC
S
TEAMER
NOTE: Be sure that any desired attachments are
connected and Water Reservoir is filled before following
these steps.
1. Plug grounded power cord into a convenient 3-prong
electrical outlet.
2. Switch Lighted On/Off Switch to “On” position.
3. Steam Ready Light will illuminate while boiler is
heating. When Steam Ready Light deactivates (2-8
minutes, depending on amount of water in Water
Reservoir) unit will automatically begin emitting steam.
4. Place garment on a clean, rust-free clothes hanger.
5. Place hanger (with garment) on Clothes Hanger Hook
(FIGURE 10).
CAUTION: Use care when handling garments on the
Clothes Hanger Hook. Pulling on the garment with
too much force may cause the unit to tip over.
6. Direct Steam Nozzle towards bottom of garment. Steam
will rise along inside and outside of fabric, removing
wrinkles. Slowly slide Steam Nozzle vertically, from
bottom to top of garment (FIGURE 11).
NOTE: Do not allow kinks to form in hose at any
time during use.
7. Direct Steam Nozzle away from garment and smooth
fabric with your free hand.
8. Repeat steps 6 & 7 as necessary until fabric is smooth
and wrinkle free.
FIGURE 10
FIGURE 11
OTHER STEAMING TIPS
• Curtains and draperies may be steamed while still hanging.
• To remove wrinkles from towels, handkerchiefs and napkins, drape them over a rod or
towel rack and gently steam them.
• Heavier fabrics may require repeated steaming to effectively remove wrinkles.
• To remove exceptionally stubborn wrinkles steam both sides of fabric.
• For additional assistance in removing tough wrinkles, or to remove lint and other particles,
attach Fabric Brush or Lint Remover to Steam Nozzle (see Attaching Lint Remover and
Fabric Brush section on page 8 of this manual).
• Use Press Pad in order to steam difficult spots and edges and to create creases in fabric.
Slide your hand through the velcro strap on back of Press Pad to secure it to your hand.
This will protect your hand from the flow of hot steam. Then steam fabric while pressing it
firmly but gently against the Press Pad.
9. When you have completed your steaming tasks, immediately switch Lighted On/Off
Switch to “Off” position and unplug power cord from electrical outlet. Refer to Proper
Storage section on page 11 of this manual for information on proper cleaning and storage
of Fabric Steamer.