Toshiba V.90 - Manual (Page 54)

AT Commands
AT command formats
35
+MS= , , <0>, , <0>,
This command is used to set the various parameters described
below:
Example: +MS=V90C,1,0,0,0,0
This sets the modulation to be V.90 and the speed negotiations
to use automode. This is the modem default.
Example: +MS=V90C,1,0,0,0,45333
This will limit the maximum receive connect carrier speed to
45,333 bps in V.90 mode.
+MS?
This command returns the current +MS sub parameter settings.
+MS=?
This command returns a listing of all supported values for each
sub parameter. For the current modem driver, the response is the
following:
A modem connect protocol string, such as
V.90 or 56K
0 Disables automatic modulation negotiation
1 Enables automatic modulation negotiation
The maximum transmit rate. If set to 0, then
the max rate will be determined by the
modulation means selected in the
and settings.
Sets the fastest receive carrier speed. If set to
0, then max rate will be determined by the
modulation means selected in the
and settings.