Topcom OGATECH OG-S60 - Manual (Page 27)

OGATECH OG-S60/TWIN/TRIPLE/QUATTRO 27
OGATECH OG-S60/TWIN/TRIPLE/QUATTRO
ENGLISH
6.2 Removing a handset
You can remove a handset with a base to allow another handset to be registered
1.
Enter the menu by pressing /OK
2. Select SETUP using the up and down keys
3. Press OK
4. Select DEL HANDSET using the up and down keys
5. Press OK
6. Enter the 4 digit base PIN code
7. Press OK
8. Select the handset to be removed
9. Press OK to validate
6.3 Setting up a handset on another base
If you want to use a OGATECH OG-S60 handset with a base of another model. The base
must be GAP compatible.
1.
To put the base in registration mode, refer to the base user manual.
2. Carry out operations 3 to 10 from the paragraph 6.1.
6.4 Selecting a base
The handsets can be registered up to 4 bases simultaneously.
To select a base:
1.
Enter the menu by pressing /OK
2. Select REGISTER using the up and down keys
3. Press OK
4. Select SELECT BASE using the up and down keys
5. Press OK
6. Select a base or select AUTO using the up and down keys
7. Press OK
When selecting the base, the currect selected base in indicated by a blinking base number.
If you select ‘Auto’ the handset will automatically search for another base when you are out
of range!
7 Troubleshooting
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the
batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly
connected Check the telephone cord
connection
The line is occupied by
another handset Wait until the other handset
hangs up