Troy-Bilt 4510 - Manual (Page 15)

Operating Tips
NOTE: Allow the engine to warm up for a few minutes. The
engine will not develop full power until it reaches operating
temperature.
WARNING! The temperature of the muffler and
the surrounding areas may exceed 150° F. Avoid
these areas.
If possible, remove snow immediately after it falls. 1.
Discharge snow downwind whenever possible. 2.
Slightly overlap each previous path. 3.
Set the skid shoes 1/4” below the shave plate for normal 4.
usage. Adjust them upward for hard-packed snow and
downward when using on gravel or crushed rock.
Replacing Shear Pins
Each of the six auger spiral assemblies are secured to the spiral
shaft with a shear pin and cotter pin. If the auger should strike a
foreign object or ice jam, the snow thrower is designed so that
the pins may shear. If the augers will not turn, check to see if the
pins have sheared. See Fig. 5-1.
CAUTION: Never replace the auger shear pins with
anything other than OEM Part No. 738-04155
replacement shear pins. Any damage to the auger
gearbox or other components as a result of failing to
do so will NOT be covered by your snow thrower’s
warranty.
WARNING! Always turn off the snow thrower’s
engine and remove the key prior to replacing shear
pins.
To Engage Drive
Move the shift lever into one of the six forward (F) positions 1.
or two reverse (R) positions. Select a speed appropriate for
the snow conditions and a pace you’re comfortable with.
NOTE: Use slower speeds in higher snow and/or until you are
familiar with the snow thrower operation.
Squeeze the drive control against the handle the snow thrower 2.
will move. Release it and drive motion will stop.
CAUTION: Never move the shift lever without first
releasing the wheel drive control. Doing so will
cause premature wear on the drive system’s friction
wheel
To turn the snow thrower to the left or right, squeeze the 3.
respective wheel steering control. Refer to Figure 4-1.
To Engage Augers
To engage the augers and start throwing snow, squeeze 1.
the auger control against the left handle. Release to stop
the augers.
While the auger control is engaged, squeeze the drive control
2.
to engage the interlock mechanism and to drive the snow
thrower. The interlock mechanism locks the auger control
so you can turn the chute control without interrupting the
snow throwing process.
Release the auger control; the interlock mechanism should
3.
keep the auger control engaged until the drive control is
released.
Release the drive control to stop both the augers and
4.
the wheel drive. To stop the auger, both levers must be
released.
Figure 5-1
Shear Pin
Cotter Pin
15 s
ectiOn
5 — O
peratiOn