Topcom BUTLER 2562 - Manual (Page 35)

BUTLER 2562 35
ENGLISH
8. TROUBLE SHOOTING
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly connected Check the telephone cord connection
The line is occupied by another Wait until the other handset hangs up
handset
The icon flashes Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the base
Base or handset do
not ring The handset is not registered Register the handset on the base
on the base
The ringing volume is zero or low Adjust the ringing volume
Tone is good, but
there is
no communication The dialling mode is wrong Adjust the dialling mode (pulse/tone)
Not possible to
transfer a call on
PABX The FLASh time is too short Set the unit to Long Flash time
Telephone does not
react to pressing the
keys Manipulation error Remove the batteries and
but them back in place
HL_B2562_scan.book Page 35 Monday, December 29, 2003 12:15 PM