Topcom Twin Talker 3800 - Manual (Page 5)

Topcom Twintalker 3800 3
Topcom Twintalker 3800
ENGLISH
6 Disposal of the device (environment)
At the end of the product lifecycle, you should not throw this product into the
normal household garbage but bring the product to a collection point for the
recycling of electrical and electronic equipments. The symbol on the product,
user guide and/or box indicate this.
Some of the product materials can be re-used if you bring them to a recycling point. By
reusing some parts or raw materials from used products you make an important contribution
to the protection of the environment. Please contact your local authorities in case you need
more information on the collection points in your area.
7 Using a PMR device
To communicate between PMR devices they need to be all set on the same channel and
CTCSS code and within receiving range (up to max. 5 km in open field). Since these devices
use free frequency bands (channels), all devices in operation share these channels(total 8
channels). Therefore, privacy is not garanteed. Anybody with a PMR set to your channel can
overhear the conversation. If you want to communicate (transmitting a voice signal) you
need to press the
-button .
Once this button pressed, the device will go into transmit mode and you can speak into the
microphone. All other PMR devices in range , on the same channel and in standby mode (not
transmitting) will hear your message. You need to wait until the other party stops transmitting
before you can reply to the message. At the end of each transmission the unit will send a
beep if the Roger Beep is enabled (see chapter 14.10). To reply, just press the
-button
and speak into the microphone.
8 Included in the package
• 2 x Twintalker 3800
• 2 x Beltclip
• 2 x Power adapter
• 2 x NiMH (3 x AA) battery pack
• 2 x Earpiece with microphone and PTT button
• 2 x Lan yard
• User guide
• Card with service address and Hotline
10
10
If 2 or more users press the - button at the same time the receiver
will receive only the stongest signal and the other signal(s) will be
supressed. Therefore you should only transmit a signal (press
-
button ) when the channel is free.
10
10