Tyco Electronics M7200 - Manual (Page 20)

MM-011553-001, Rev. A
20
NAME TONE DESCRIPTION
Emergency Cleared
Tone
one long low-pitched tone Sounds when an emergency is cleared.
Selective Call Ring
Tone a ringing tone similar to a
telephone
Ringing is repeated every four (4) seconds until the call
is accepted or rejected by the radio being called or until
the network drops the call if unanswered after one (1)
minute.
PSTN Ring Tones
a single medium-pitch
reiterative tone.
Two ring tone - one generated by the radio when there is
an incoming telephone call or an outgoing telephone call
attempt is waiting for the telephone interconnect gateway
equipment to dial the Public Switched Telephone
Network (PSTN). The second ring tone sounds when the
gateway equipment has dialed the number.
V-TAC On Tone
a quick high-low-high-low-
pitched beep.
This tone sounds when a V-TAC automatically transitions
from the mobile-only mode to one of the V-TAC XCOV
modes, and from V-TAC XCOV mode to mobile radio
mode. It does not sound on manual transition.
V-TAC Client
Attach/Detach Tone
a quick high-pitched beep.
This tone sounds when a portable radio (“client”)
attaches to or detaches from the V-TAC.
Roam Tone
Two short tones, one high-
pitched and one low-pitched Sounds when the radio transitions from one radio base
station site to another.
Out of Range Tone three brief tones
If enabled via programming, sounds at a programmable
interval while the radio is in a state of persistent
deactivation.
6.12 BASIC MENU STRUCTURE
Table 6-4 illustrates the basic M7200 OpenSky menu structure. Menu items will vary depending upon
system programming, radio hardware, and optional configurations. All menus except the dwell display
menu can be turned off by network administration personnel.