Toshiba SD-P4000 User Manual

Page 19

Connections

MPEG2 sound
You can enjoy motion picture and live concert DVD video discs encoded via the MPEG2 recording system with dynamic
realistic sound by connecting an amplifier equipped with an MPEG2 audio decoder or MPEG2 audio processor.

Connecting to an amplifier equipped with an MPEG audio decoder

Connecting to an amplifier equipped with a digital audio input

2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital audio input
and speaker system (right and left front speakers).
Note: PCM audio is limited to DVD or CD playback.

Notes:
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the AC-3 RF input of a Dolby Digital Receiver.

This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO
OUT jack of the TV/DVD.

• Connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the “COAXIAL” input of a Receiver or Processor.
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the TV/DVD to other equipment, be sure to turn off the power and unplug all of the equipment from the

wall outlet before making any connections.

• The output sound of the TV/DVD has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate

listening level. Otherwise, the speakers may and your hearing be damaged by a sudden high volume sound.

• Turn off the amplifier before you connect or disconnect the TV/DVD’s power cord. If you leave the amplifier power on, the

speakers may be damaged.

Amplifier equipped with an

MPEG2 audio decoder

To COAXIAL
type digital
audio input

Ω coaxial cable (not supplied)

Amplifier equipped with a

Digital audio input

To COAXIAL
type digital
audio input

Ω coaxial cable (not supplied)

Rear lower right of the TV

To COAXIAL DIGITAL
AUDIO OUT

J5N00221C [E] (P14-25)

15/09/2004, 4:24 PM