Topfield TF 5100 PVR - Manual (Page 18)

12 Setup
2.4 Connecting up your digital receiver
There are several ways to set up the digital receiver. Set up
the digital receiver suitably to your television and other appli-
ances. If you have any problem with your setup or need help,
contact your dealer.
2.4.1 Connecting to the antenna
Whatever sort of connection you have between the digital re-
ceiver and the television, you need to connect the digital re-
ceiver to your television antenna so that it can receive digital
television services.
Connect the antenna cable to the ANT 1
socket on the back panel of the digital re-
ceiver.
However your digital receiver is connected
to the television, you must ensure that there
is a connection to both the ANT 1 and ANT
2
connectors on your digital receiver, so that
both tuners work properly.
Normally you do that by using a loop cable to link from the
RF LOOP 1 OUT
connector to the ANT 2 connector.
NOTE
However, if you are in a weak signal area, or are using a signal
amplifier with more than one output, you may achieve better
results by connecting a cable from the antenna or amplifier di-
rectly to the ANT 2 connector rather than using the loop cable.
If you have another digital receiver, link it from the RF LOOP
2 OUT
connector.
2.4.2 Connecting to your television
Between all the following connectors of your digital receiver,
we recommend you use the first connector to get best picture