The blocks, Phaser, Pan+trem block – TC Electronic G-Force User Manual

Page 39: Tremolo

Phaser

PHASER

Speed
Controls the speed of the Phaser.

Tempo
The Tempo parameter sets the relationship to the
global Tempo e.g. if you set it to 1/4T you will get
quarter note triplets of the tapped tempo. 1/4 equals
the BPM (tapped Tempo).
If you select “Ignored” the current parameter will use
the Preset value and will not be affected by the Global
Tempo.

Depth
Adjusts the Depth of the Phaser.

Order
Sets the number of filters used to produce the Phaser.
The three possibilities 4, 8 and 12 are very different
sounding. Check them out.

Feedback Level
Controls the amount of feedback in the Phaser. Note
that this parameter can be negative, meaning feedback
in reversed phase.

Instrument Mode
With the mode parameter you can choose between the
guitar or bass range of the Phaser.

Mix
Mix between direct sound and effect.

In Level
Controls the input level of the block.

Out Level
Controls the output level of the block.

Mute mode
See Mute mode in the introduction of this chapter.

Pan+Trem block

A Panner is basically a change of the level opposite in
left and right channels. An LFO is connected to these
levels and turns them up and down. A Tremolo is also
a change of level controlled by an LFO except the level
change in left and right channels are identical. So the
basic difference between a Panner and a Tremolo is
whether the level change of left and right channels is
opposite or identical.
This Panner has a surround range, meaning that it will
pan further than a normal stereo image.
The Tremolo has flexibility that you will not see in any
stomp box.

TREMOLO / PAN

Tremolo

Speed
Controls the how fast the Tremolo is pulsing.

Depth
Will set the intensity of the Tremolo, or how deep it
sweeps.

THE BLOCKS