Technicolor - Thomson TCW710 - Manual (Page 25)

Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only. 17
Overview
Front Panel
The following illustration shows the front panel of the Gateway machine:
The LEDs on the front panel are described in the table below (from left to right):
TCW710 WLAN Ethernet USB
Cable
Link
Internet Description
OFF OFF OFF OFF FLASH Tuning (Searching downstream signal)
OFF OFF OFF FLASH FLASH
Ranging - Awaiting Response
(DS carrier acquire, ranging in process but RNG-RSP
has not been detected)
OFF OFF OFF FLASH FLASH
Any RNG-RSP detected
(Normalizing power level and timing offset)
OFF OFF FLASH FLASH FLASH
Connecting
(Ranging complete, DHCP in progress)
OFF FLASH FLASH FLASH FLASH
Configuring
(DHCP complete, configuration file download in
process)
FLASH FLASH FLASH FLASH FLASH
Registering and Baseline Privacy Initializing
(configuration file download complete, initialize BPI if
BPI is ON, registration in process)
Start-up
Operation
Enter Normal Operation Mode Registration complete
X X X X
OFF
ON
Internet ON-OFF switch off
Internet ON-OFF switch on
X X X
OFF
FLASH
ON
X
NO Cable Link
Cable BSS/OSS has set the CM into de-activated
state
CM is registered
Normal
Operation
X X
OFF
ON
X X
NO USB carrier present
USB carrier present, no traffic