Toshiba SD-R1202 User Manual

Page 8

The following steps must be performed to properly install your CD-RW/DVD-

ROM.
! Set drive’s jumpers
! Connect audio cable
! Attach IDE BUS cable
! Connect power cable
! Mount CD-RW/DVD-ROM
! Install CyberLink PowerDVD

™

software (used for viewing DVD movies)

! Install VOB InstantCD/DVD software (used for recording CDs)

SETTING JUMPERS

The mode select jumpers are six (6) straight pins located on the rear of the CD-RW/
DVD-ROM. By placing a jumper on the pins, you can select the following func-
tions:

CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)

Mode Select Jumpers

In most installations, jumper should remain in MA (Master) position (factory
default). It is recommended that you install your CD-RW/DVD-ROM only on the
secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive
would then be the Master, and you should set your CD-RW/DVD-ROM to the
Slave position (SL).

PLACING CD-RW/DVD-ROM INSIDE YOUR COMPUTER

Now that you have set your drive’s jumpers, you are ready to install your
CD-RW/DVD-ROM inside your computer.

☞

IMPORTANT: Disconnect power from your computer system before

beginning installation.