Toshiba SD-R1202 - Manual (Page 13)

1. Turn CD-RW/DVD-ROM drive power OFF.
2. Insert a solid bar (i.e. large paper clip*) into Emergency Eject hole and push
in as shown in the picture below.
3. CD-RW/DVD-ROM tray will open/eject.
This procedure cannot be repeated without cycling the drive’s power. After the
media is removed and the loading tray is closed, the tray will not reopen without
first turning the power ON/OFF.
* Use a bar that is less than 1.5mm in diameter. Do not insert more than 50mm
in depth as this may damage the drive.
CD-RW/DVD-ROM FRONT PANEL
The photo below illustrates the following features of the SD-R1202 CD-RW/
DVD-ROM front panel:
" " " " "
Loading Tray
# # # # #
Eject Button
$ $ $ $ $
Busy Light
% % % % %
Emergency Eject Hole
CD-RW/DVD-ROM BACK PANEL
The photo below illustrates the following features of the SD-R1202 CD-RW/DVD-
ROMs back panel:
" " " " "
Digital Audio Out Connector
% % % % %
ATAPI Connector
$ $ $ $ $
Analog Audio Out Connector
& & & & &
Power Connector
# # # # #
Mode Select Jumper