TC electronic SDN BHD P2 - Manual (Page 24)

22
SYSTEM - NET PAGE & ICON VIEWS
The upper part of this page holds information
on the current software versions and the serial
number of the accessed unit.
Network identification
A simple naming function that enables you to
name each connected unit.
UI - Icon Views
On the Icon Setup page two sub-pages are
available for controlling the TC Icon
appearance.
Fader appearance
Three options are available. Changes will take
place next time you open the TC Icon.
Faders at bottom
Disable:
No lock function is active.
Lock Wizard:
Wizard function is disabled and cannot be
activated via the front panel WIZARD key.
Lock Recall:
No presets can be recalled via the eight front
panels preset keys but the Wizard function is
enabled.
Lock Panel:
The entire front panel, recall functions, Bypass
and Card dump functionality is disabled.
Lock Activation
The two Lock activation modes defines how the
Lock function can be activated/deactivated from
the front panel.
Hold : Lock/unlock can be done by holding
Lock key for 2 seconds
Code : Four digit code entered via the
eight front panel controls is needed
to unlock front panel controls.
The unlock code must be entered within
5 seconds.
Bypass Mode
Press the round BYPASS key to activate.
Normal
: No Delay in bypass and
Dither is active
Relay : Bit transparent digital and
analog Bypass Relay
No Codec Delay : No delay in bypass.
Bypass bit transparency.
Codec Delay : Delay active in Bypass.
Bypass bit transparency.
Lock Code/Unlock Code
Enter the lock/unlock codes that needs to be
entered to lock/unlock front panel controls when
in Lock mode (see above).
Yellow LED Threshold
Analog In, Analog Out & Out Threshold
Range: 0 to - 20dB
Sets the response Threshold for the two yellow
digits in the In/Out meters.